Negative pressure pulmonary oedema: A rare case report of two brothers

Negative Pressure Pulmonary O/Edema (NPPE) is potentially life-threatening and it is a general anaesthesia side effect. We are mentioning a rare case report of two brothers who were referred to our hospital for elective surgeries (varicocele and septoplasty) in a 3 years period. Both of them were athletes and their coagulation factors were disturbed after surgeries. Pulmonary oedema was healed after treating it by reintubation, mechanical ventilation by Positive End-Expiratory Pressure (PEEP), diuretics, morphine, Fresh Frozen Plasma (FFP) and liquid bounding

Robustness and mode selectivity in parity-time (PT) symmetric lasers

We investigate two important aspects of PT symmetric photonic molecule lasers, namely the robustness of their single longitudinal mode operation against instabilities triggered by spectral hole burning effects, and the possibility of more versatile mode selectivity. Our results, supported by numerically integrating the nonlinear rate equations and performing linear stability analysis, reveals the following: (1) In principle a second threshold exists after which single mode operation becomes unstable, signaling multimode oscillatory dynamics, (2) For a wide range of design parameters, single mode operation of PT lasers having relatively large free spectral range (FSR) can be robust even at higher gain values, (3) PT symmetric photonic molecule lasers are more robust than their counterpart structures made of single microresonators; and (4) Extending the concept of single longitudinal mode operation based on PT symmetry in millimeter long edge emitting lasers having smaller FSR can be challenging due to instabilities induced by nonlinear modal interactions. Finally we also present a possible strategy based on loss engineering to achieve more control over the mode selectivity by suppressing the mode that has the highest gain (i.e. lies under the peak of the gain spectrum curve) and switch the lasing action to another mode

Realizing Spin-Hamiltonians in Nanolaser Lattices

We demonstrate both theoretically and experimentally that coupled metallic nanolasers can be used to emulate spin-Hamiltonians. Depending on the geometry of the array, we observe ferromagnetic and antiferromagnetic behaviors, as well as geometric frustration

Power-law scaling of extreme dynamics near higher-order exceptional points

We investigate the extreme dynamics of non-Hermitian systems near higher-order exceptional points in photonic networks constructed using the bosonic algebra method. We show that strong power oscillations for certain initial conditions can occur as a result of the peculiar eigenspace geometry and its dimensionality collapse near these singularities. By using complementary numerical and analytical approaches, we show that, in the parity-time (PT) phase near exceptional points, the logarithm of the maximum optical power amplification scales linearly with the order of the exceptional point. We focus in our discussion on photonic systems, but we note that our results apply to other physical systems as well

Parity-time-symmetric coupled microring lasers operating around an exceptional point

The behavior of a parity-time (PT) symmetric coupled microring system is studied when operating in the vicinity of an exceptional point. Using the abrupt phase transition around this point, stable single-mode lasing is demonstrated in spectrally multi-moded micro-ring arrangements.Comment: 5 pages, 6 figure

Advances in small lasers

M.T.H was supported by an Australian Research council Future Fellowship research grant for this work. M.C.G. is grateful to the Scottish Funding Council (via SUPA) for financial support.Small lasers have dimensions or modes sizes close to or smaller than the wavelength of emitted light. In recent years there has been significant progress towards reducing the size and improving the characteristics of these devices. This work has been led primarily by the innovative use of new materials and cavity designs. This Review summarizes some of the latest developments, particularly in metallic and plasmonic lasers, improvements in small dielectric lasers, and the emerging area of small bio-compatible or bio-derived lasers. We examine the different approaches employed to reduce size and how they result in significant differences in the final device, particularly between metal- and dielectric-cavity lasers. We also present potential applications for the various forms of small lasers, and indicate where further developments are required.PostprintPeer reviewe

Room temperature plasmonic lasing in a continuous wave operation mode from an InGaN/GaN single nanorod with a low threshold

It is crucial to fabricate nano photonic devices such as nanolasers in order to meet the requirements for the integration of photonic and electronic circuits on the nanometre scale. The great difficulty is to break down a bottleneck as a result of the diffraction limit of light. Nanolasers on a subwavelength scale could potentially be fabricated based on the principle of surface plasmon amplification by stimulated emission of radiation (SPASER). However, a number of technological challenges will have to be overcome in order to achieve a SPASER with a low threshold, allowing for a continuous wave (cw) operation at room temperature. We report a nano-SPASER with a record low threshold at room temperature, optically pumped by using a cw diode laser. Our nano-SPASER consists of a single InGaN/GaN nanorod on a thin SiO2 spacer layer on a silver film. The nanorod containing InGaN/GaN multi-quantum-wells is fabricated by means of a cost-effective post-growth fabrication approach. The geometry of the nanorod/dielectric spacer/plasmonic metal composite allows us to have accurate control of the surface plasmon coupling, offering an opportunity to determine the optimal thickness of the dielectric spacer. This approach will open up a route for further fabrication of electrically injected plasmonic lasers